Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.?
2.
Left-rear acceleration sensor performance check:
Left-rear acceleration sensor performance check
?1.
Check the parameter(s) below with the HDS.
Signal
Current conditions
Values
Unit
Left Rear Acceleration Sensor Voltage
Is there about 0 V?
YES
Go to step 3.
NO
Go to step 5.
3.
Open wire check (ADS SVCC line):
Open wire check (ADS SVCC line)
?1.
Turn the vehicle to the OFF (LOCK) mode.
?2.
Disconnect the following connectors.
Adaptive damper control unit 24P connector
Front acceleration sensor 3P connector
?3.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
Adaptive damper control unit 24P connector: disconnected
Front acceleration sensor 3P connector: disconnected
Repair a short to body ground in the wire between the adaptive damper control unit and the front acceleration sensor.?
NO
The ADS SVCC wire is OK. Check for loose terminals and poor connections in the adaptive damper control unit 24P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the adaptive damper control unit.?
Repair a short to body ground in the wire between the adaptive damper control unit and the front acceleration sensor.?
NO
The ADS FR R G wire is OK. Check for loose terminals and poor connections in the adaptive damper control unit 24P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the adaptive damper control unit.?
