Solenoid Wire Harness Removal and Installation

NOTE:
Keep all foreign particles out of the transmission.
The solenoid wire harness and the transmission fluid temperature sensor are not available separately. Replace them as a set.


NOTE: The actual transmission fluid (HCF-2) capacity will vary from the specified capacity based on the length of time the transmission fluid pan is off the transmission. Avoid leaving the transmission fluid pan off for extend periods of time.

6. Transmission Fluid Strainer - Remove
1.
Remove the transmission fluid strainer (A) with the O-ring (B).
2.
Clean the inlet opening (A) of the transmission fluid strainer (B) thoroughly with compressed air.
3.
Check that it is in good condition and that the inlet opening is not clogged.
4.
Test the strainer by pouring clean transmission fluid through the inlet opening, and replace it if it is clogged or damaged.

8. Solenoid Wire Harness - Remove
1.
Disconnect the connectors (A).
NOTE: Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.
2.
Remove the transmission fluid temperature sensor (B).
3.
Remove the ground terminals (C) and the harness clamps (D).


NOTE:
Keep all foreign particles out of the transmission.
The solenoid wire harness and the transmission fluid temperature sensor are not available separately. Replace them as a set.
Apply a light coat of clean transmission fluid on the O-ring before installation.

1. Solenoid Wire Harness - Install
1.
Connect the connectors (A).
2.
Install the transmission fluid temperature sensor (B).
3.
Install the ground terminals (C) and the harness clamps (D).

3. Transmission Fluid Strainer - Install
1.
Install the transmission fluid strainer (A) with a new O-ring (B).
NOTE: Be careful not to damage the solenoid wire harness and the O-ring while installing the transmission fluid strainer.