Wiper Motor Removal and Installation
Windshield

2. Linkage Assembly - Remove
1.
Disconnect the connector (A).
2.
Remove the harness clip (B).
3.
Remove the wiper linkage assembly (C).

3. Windshield Wiper Motor - Remove
1.
Note the alignment marks (A) on the wiper linkage assembly (B) and link (C), and remove the link.
2.
Remove the connecting rod (D).
3.
Remove the wiper motor (E).

Rear Window

3. Rear Window Wiper Motor - Remove
1.
Disconnect the connector (A).
2.
Remove the rear window wiper motor (B).
3.
Remove the cap (C).

Windshield

1. Windshield Wiper Motor - Install
NOTE: Bolt threads are not provided on the new wiper motor. Install the wiper motor to the linkage as follows:
1.
Before installing the wiper motor, connect the windshield wiper motor connector.
2.
Turn the vehicle to the ON mode, and then turn the vehicle to the OFF (LOCK) mode.
3.
Turn the wiper/washer switch WASH within 10 seconds, to return the wiper motor shaft to lower auto-stop position.
4.
Disconnect the windshield wiper motor connector.

NOTE:
Apply multipurpose grease to moving parts.
Check the wiper motor operation.
5.
Set the motor (A) and the linkage (B), and tighten the bolts until the bolt head just contacts the linkage.

NOTE:
Install the provided self-tapping bolts.
Keep the bolts perfectly straight while bolting them in.
Do not use air tools and impact wrenches.
6.
Loosen the bolts, then retighten the bolts to the specified torque.
7.
Align the marks (C) on the link (D) and linkage, and install the link.
8.
Install the connection rod (E).

2. Linkage Assembly - Install
1.
Install the wiper linkage assembly (A).
NOTE: Tighten the bolts in the sequence shown.
2.
Install the harness clip (B).
3.
Connect the connector (C).

Rear Window

1. Rear Window Wiper - Install
1.
Before reinstalling the wiper arm, connect the rear wiper motor connector, and turn the rear window wiper switch ON, then OFF to return the wiper shaft to the auto-stop position.

NOTE:
Apply multipurpose grease to the moving parts.
Check the wiper motor operation.
2.
Align the position marks (A) when installing the cap (B).
3.
Install the rear window wiper motor (C).
NOTE: Tighten the bolts in the sequence shown.
4.
Connect the connector (D).