Side Airbag Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:

If replacing the side airbag after deployment, refer to Component Replacement/Inspection After Deployment for a complete list of other parts that must also be replaced.

When troubleshooting, do not remove the front seat. Disconnect only the side airbag inflator connector from under the front seat.

1.	12 Volt Battery Terminal - Disconnect

NOTE: Wait at least 3 minutes before starting work.

2.	Front Seat - Remove

3.	Side Airbag - Remove

Remove the clips (A) and release the harness of the harness holders (B).

Remove the clip (A) and the mounting nut (B).

Pull the harness (C) from the pocket of the seat-back cover/pad.

Pull the side airbag stud bolts (A) out through the holes (B) in the reinforcing cloth (C) of the seat-back cover, then remove the side airbag (D).

4.	All Removed Parts - Install

Install the all removed parts in the reverse order of removal.

NOTE:

During installation, install the new mounting nut to the specified torque.

If the side airbag lid is secured with tape, remove the tape.

Do not open the lid on the side airbag cover.

Make sure that the seat-back cover/pad is installed properly. Improper installation may prevent proper deployment.

Be sure to install the harness so that they are not pinched or interfering with other parts.

5.	12 Volt Battery Terminal - Connect

6.	Seat Operation - Confirm

Move the front seat and the seat-back through their full ranges of movement, making sure the harness are not pinched or interfering with other parts.

7.	SRS Operation - Confirm

Turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.