Keyless Access System Symptom Troubleshooting Index
Symptom
Diagnostic procedure
Also check for
Cannot select ON mode with keyless access and with the keyless remote touching the engine start/stop switch
No. A12-1 (60 A), No. A12-3 (50 A), No. A12-4 (30 A) and No. A21 (10 A) fuse in the under-hood fuse/relay box
No. B9 (20 A), No. B31 (10 A) and No. B37 (7.5 A) fuses in the under-dash fuse/relay box
Poor connections at the keyless access control unit
Gauge control module
Keyless access control unit
Electric steering lock*
Engine start/stop switch
Cannot select ON mode with keyless access, but can select ON mode with the keyless remote touching the engine start/stop switch
No. A12-1 (60 A), No. A12-3 (50 A), No. A12-4 (30 A) and No. A21 (10 A) fuse in the under-hood fuse/relay box
No. B9 (20 A), No. B31 (10 A) and No. B37 (7.5 A) fuses in the under-dash fuse/relay box
Keyless access control unit
LF antenna
Keyless remote
Low or weak keyless remote battery
MTR CONT line open/short*
IGN TRX line open/short*
Cannot select ON mode with the keyless remote touching the engine start/stop switch, but can select ON mode with keyless access
Check the backup control unit inside the keyless access control unit
Keyless access control unit is not registered
Keyless access control unit
MTR CONT line power short*
ESLID mismatch*
MTR CONT line open/short*
IGN TRX line open/short*
Not registered
Harness/connections
The mode changes between ACC and ON, but it does not change to OFF
Check the keyless access control unit
Check the park pin switch
Check the transmission range switch
Keyless access control unit
ATP-P line open
Transmission range switch
Park pin switch
P-PIN SW line open
The mode changes between ACC and ON, but it is difficult to change to OFF
Check the keyless access control unit
Check the gauge control module
Check the park pin switch
Gauge control module
Keyless access control unit
PCM
B-CAN communication line open/short
F-CAN communication line open/short
Speed signal line open
Park pin switch
P-PIN SW line open
Engine start/stop switch does not work
Check for DTCs. If any DTC is indicated, go to the DTC troubleshooting
Accessory relay
Keyless access control unit
Engine start/stop switch
SS1 (+) line short
SS2 (-) line short
Harness
Engine does not crank (power supply is normal)
Check the brake pedal position switch
Check the power control unit inside the keyless access control unit
Keyless access control unit
STC line open/short
Brake pedal position switch
STLS line open/short
The engine starts, but stalls immediately
No power to PCM
No power to MICU
S-NET line open/short
ESL SW B line open*
Electric steering lock*
Harness/fuses
Keyless access indicator does not go off or does not come on
Gauge control module
Keyless access control unit
KEYSW line open
Harness
Immobilizer indicator does not go off or does not come on
Gauge control module
Keyless access control unit
PCM
All the doors and the trunk will not lock and unlock
Keyless access control unit
LF antenna
Driver's door lock knob switch
Door outer handle touch sensor/lock switch
Door lock actuators
Keyless remote
Low or weak keyless remote battery
Not registered
The doors will not unlock or lock with the keyless remote, but will unlock or lock with the door outer handles
Keyless remote battery dead
Keyless remote
MICU
Keyless access control unit
KEYSW line short
SS1 (+) line short
SS2 (-) line short
IG1A line short
ACC line short
B-CAN communication line
The doors will not unlock or lock with the door outer handle touch sensor or lock switch, but will unlock or lock with the keyless remote
Door outer handle touch sensor/lock switch
Keyless access control unit
Keyless remote
LF antenna
MICU
Not registered
Harness/fuses
The key-in reminder does not sound
Gauge control module
Driver's door switch
Keyless access control unit
MICU
KEYSW line open
Harness
The key-in reminder sounds when in vehicle OFF mode door is open
MICU
Keyless access control unit
Engine start/stop switch
Harness
*: Except USA CVT and A/T models