Engine Oil Pan Removal and Installation

NOTE: enu_12713377_2.0 Where icon is shown, click for further information.


1

8302_3.0_enu_15102526_4.0

enu_12713377_2.0
Detailed information, notes, and precautions
enu_12714524_1.0
Replace


2

8302_3.0_enu_15102527_4.0

enu_12713377_2.0
Detailed information, notes, and precautions
enu_12714524_1.0
Replace


NOTE: Hold the steering wheel with the steering wheel holder tool.


NOTE: Remove the necessary part(s).


NOTE:
Do not disconnect the suction hose and the discharge hose.
Do not bend the suction hose and the discharge hose excessively.
Hang the A/C compressor with a wire tie.

12. Engine - Support
1.
Support the engine with a transmission jack and a wood block under the oil pan.

14. Transmission Jack - Remove


17. Front Subframe - Move
1.
Support the front subframe with a transmission jack, then lower the front subframe to the specified width from the mounting surface.

18. Oil Pan - Remove
1.
Remove the oil pan mounting bolts.
2.
Using a flat blade screwdriver, separate the oil pan from the lower block in the places shown.


NOTE: enu_12713377_2.0 Where icon is shown, click for further information.


1

8302_3.0_enu_15126046_4.0

enu_12713377_2.0
Detailed information, notes, and precautions
enu_12714505_1.0
Torque: N·m (kgf·m, lbf·ft)
enu_12714524_1.0
Replace

1. Oil Pan - Install
1.
Apply new engine oil to the inside edge of the oil return hose.
2.
Apply liquid gasket to the lower block and the cam chain case mating surface of the oil pan, and to the inside edge of the threaded bolt holes.
3.
Tighten the bolts in three steps. In the final step, torque all bolts, in sequence, to the specified torque. Wipe off the excess liquid gasket on the each side of crankshaft pulley and flywheel.

6. Engine - Support
1.
Support the engine with a transmission jack and a wood block under the oil pan.