Carpet Removal and Installation

SRS components are located in this area. Review the SRS component locations, 2-door, 4-door and the precautions and procedures before doing repairs or service.

Front

1. Both Front Seats - Remove


2. Rear Seat Cushion - Remove


3. Both Kick Panels - Remove


4. Both B-Pillar Lower Trims - Remove (4-Door)


5. Steering Joint Cover - Remove


6. Both Front Console Covers - Remove


7. Rear Heater Joint Duct B - Remove


8. Rear Heater Middle Duct - Remove (With Rear Vent)

Remove the rear heater middle duct (A).


9. Center Console Bracket - Remove

Remove the center console bracket (A).


10. Shift Lever Housing - Remove (M/T)

Remove the shift lever housing:

11. Shift Lever - Remove (A/T)


12. Shift Lever - Remove (CVT)


13. Front Carpet - Remove

1.
Remove the clips (A).





2.
2-door: Disconnect the front interior LF antenna connector (A).






3.
Remove the clips (A, B).

4.
2-door: Cut the front carpet (C) in the area (D) as shown.

5.
4-door: Release the hook and loop fasteners (E).

6.
Pull out the seat harnesses (F), then remove the front carpet.





Driver's side

Passenger's side
7.
If necessary, remove the front clip base (A).





8.
If necessary, remove the floor mat holder (A).

Rear

1. Both Front Seats - Remove


2. Rear Seat Cushion - Remove


3. Both Rear Side Trim Panels - Remove (2-Door)


4. Both B-Pillar Lower Trims - Remove (4-Door)


5. Rear Heater Middle Duct - Remove (With Rear Vent)

Remove the rear heater middle duct.

6. Center Console Bracket - Remove

Remove the center console bracket.

7. Rear Carpet - Remove

2-door

4-door
1.
Remove the rear carpet (A).





2.
If necessary, remove the rear clip base (A).


SRS components are located in this area. Review the SRS component locations, 2-door, 4-door and the precautions and procedures before doing repairs or service.

Front

1. Front Carpet - Install

1.
Install the floor mat holder (A).





Driver's side

Passenger's side
2.
Install the front clip base (A).






3.
2-door: When installing the new front carpet (A), cut the front carpet in the area (B) as shown.

4.
Pass the seat harnesses (C) through the hole in the front carpet, then install the front carpet.

5.
4-door: Install the hook and loop fasteners (D).

6.
Install the clips (E, F).





7.
2-door: Connect the front interior LF antenna connector (A).





8.
Install the clips (A).

2. Shift Lever - Install (CVT)


3. Shift Lever - Install (A/T)


4. Shift Lever Housing - Install (M/T)

Install the shift lever housing:

5. Rear Heater Middle Duct - Install (With Rear Vent)

Install the rear heater middle duct (A).


6. Rear Heater Joint Duct B - Install


7. Both Front Console Covers - Install


8. Center Console Bracket - Install

Install the center console bracket (A).


9. Steering Joint Cover - Install


10. Both B-Pillar Lower Trims - Install (4-Door)


11. Both Kick Panels - Install


12. Rear Seat Cushion - Install


13. Both Front Seats - Install


Rear

1. Rear Carpet - Install

1.
Install the rear clip base (A).





2-door

4-door
2.
Install the rear carpet (A).

2. Center Console Bracket - Install

Install the center console bracket.

3. Rear Heater Middle Duct - Install (With Rear Vent)

Install the rear heater middle duct.

4. Both B-Pillar Lower Trims - Install (4-Door)


5. Both Rear Side Trim Panels - Install (2-Door)


6. Rear Seat Cushion - Install


7. Both Front Seats - Install