DTC Troubleshooting: B00C0-87 (KA/KC) - Honda Accord CR/CT 2012-2017

DTC Troubleshooting: B00C0-87

DTC B00C0-87: No Signal From the Front Passenger's Weight Sensor (front inner side)

NOTE:

	Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number, and that they were properly installed.
	Before doing this troubleshooting procedure, review SRS Precautions and Procedures, General Troubleshooting Information, and 12 Volt Battery Terminal Disconnection and Reconnection.
	Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS unit software, and retest.

DTC Description	DTC
B00C0-87 No signal from the front passenger's weight sensor (front inner side)

Problem verification:

Problem verification

?1.	Clear the DTCs with the HDS.

?2.	Turn the vehicle to the ON mode, then wait for 10 seconds.

?3.

Check for DTCs with the HDS.

DTC Description	DTC
B00C0-87 No signal from the front passenger's weight sensor (front inner side)

Is DTC B00C0-87 indicated?


	YES

The failure is duplicated. Go to step 2.


	NO

Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.?

Open wire check (SWS? line):

Open wire check (SWS? line)

?1.	Turn the vehicle to the OFF (LOCK) mode.

?2.	Disconnect the negative cable from the 12 volt battery, then wait at least 3 minutes.

?3.

Disconnect the following connectors.

SRS unit connector B (39P)

Front passenger's weight sensor (front inner side) 3P connector (on the front passenger's seat wire harness)

?4.

Measure the resistance between test points 1 and 2.

Test condition	Vehicle OFF (LOCK) mode
Test condition	SRS unit connector B (39P): disconnected
	Front passenger's weight sensor (front inner side) 3P connector (on the front passenger's seat wire harness): disconnected
Test point 1	SRS unit connector B (39P) No. 26
Test point 2	Front passenger's weight sensor (front inner side) 3P connector No. 1 (on the front passenger's seat wire harness)

Is there 1.0 ? or less?


	YES

The SWS? wire is OK. Go to step 3.


	NO

Open in the right side wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.?

Open wire check (SWS? line):

Open wire check (SWS? line)

?1.

Measure the resistance between test points 1 and 2.

Test condition	Vehicle OFF (LOCK) mode
Test condition	SRS unit connector B (39P): disconnected
	Front passenger's weight sensor (front inner side) 3P connector (on the front passenger's seat wire harness): disconnected
Test point 1	SRS unit connector B (39P) No. 28
Test point 2	Front passenger's weight sensor (front inner side) 3P connector No. 3 (on the front passenger's seat wire harness)

Is there 1.0 ? or less?


	YES

The SWS? wire is OK. Go to step 4.


	NO

Open in the right side wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.?

Open wire check (SWSS line):

Open wire check (SWSS line)

?1.

Measure the resistance between test points 1 and 2.

Test condition	Vehicle OFF (LOCK) mode
Test condition	SRS unit connector B (39P): disconnected
	Front passenger's weight sensor (front inner side) 3P connector (on the front passenger's seat wire harness): disconnected
Test point 1	SRS unit connector B (39P) No. 30
Test point 2	Front passenger's weight sensor (front inner side) 3P connector No. 2 (on the front passenger's seat wire harness)

Is there 1.0 ? or less?


	YES

The SWSS wire is OK. Go to step 5.


	NO

Open in the right side wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.?

Shorted wire check (SWSS line to power) :

Shorted wire check (SWSS line to power)

?1.

Disconnect the following connectors.

Front passenger's weight sensor (rear inner side) 3P connector (on the front passenger's seat wire harness)

Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness)

Front passenger's weight sensor (rear outer side) 3P connector (on the front passenger's seat wire harness)

?2.	Reconnect the negative cable to the 12 volt battery.

?3.	Turn the vehicle to the ON mode.

?4.

Measure the voltage between test points 1 and 2.

Test condition	Vehicle ON mode
Test condition	SRS unit connector B (39P): disconnected
	Front passenger's weight sensor (front inner side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (rear inner side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (rear outer side) 3P connector (on the front passenger's seat wire harness): disconnected
Test point 1	SRS unit connector B (39P) No. 30
Test point 2	Body ground

Is there 0.2 V or less?


	YES

Go to step 6.


	NO

Short to power in the right side wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.?

Shorted wire check (SWSS line) :

Shorted wire check (SWSS line)

?1.	Turn the vehicle to the OFF (LOCK) mode.

?2.	Disconnect the negative cable from the 12 volt battery, then wait at least 3 minutes.

?3.

Measure the resistance between test points 1 and 2.

Test condition	Vehicle OFF (LOCK) mode
Test condition	SRS unit connector B (39P): disconnected
	Front passenger's weight sensor (front inner side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (rear inner side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (rear outer side) 3P connector (on the front passenger's seat wire harness): disconnected
Test point 1	SRS unit connector B (39P) No. 30
Test point 2	Body ground

Is there an open circuit, or at least 1 M??


	YES

Go to step 7.


	NO

Short to ground in the right side wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.?

Shorted wire check (SWSS line to SWS? line) :

Shorted wire check (SWSS line to SWS? line)

?1.

Measure the resistance between test points 1 and 2.

Test condition	Vehicle OFF (LOCK) mode
Test condition	SRS unit connector B (39P): disconnected
	Front passenger's weight sensor (front inner side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (rear inner side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (rear outer side) 3P connector (on the front passenger's seat wire harness): disconnected
Test point 1	SRS unit connector B (39P) No. 30
Test point 2	SRS unit connector B (39P) No. 28

Is there an open circuit, or at least 1 M??


	YES

Go to step 8.


	NO

Short to ground in the right side wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.?

Shorted wire check (SWSS line to SWS? line) :

Shorted wire check (SWSS line to SWS? line)

?1.

Measure the resistance between test points 1 and 2.

Test condition	Vehicle OFF (LOCK) mode
Test condition	SRS unit connector B (39P): disconnected
	Front passenger's weight sensor (front inner side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (rear inner side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness): disconnected
	Front passenger's weight sensor (rear outer side) 3P connector (on the front passenger's seat wire harness): disconnected
Test point 1	SRS unit connector B (39P) No. 30
Test point 2	SRS unit connector B (39P) No. 26

Is there an open circuit, or at least 1 M??


	YES

Go to step 9.


	NO

Short to another wire in the right side wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.?

Front passenger's weight sensor check:

Front passenger's weight sensor check

?1.	Substitute a known-good front passenger's weight sensor.

?2.

Reconnect the following connectors.

SRS unit connector B (39P)

Front passenger's weight sensor (front inner side) 3P connector (on the front passenger's seat wire harness)

Front passenger's weight sensor (rear inner side) 3P connector (on the front passenger's seat wire harness)

Front passenger's weight sensor (front outer side) 3P connector (on the front passenger's seat wire harness)

Front passenger's weight sensor (rear outer side) 3P connector (on the front passenger's seat wire harness)

?3.	Reconnect the negative cable to the 12 volt battery.

?4.	Clear the DTCs with the HDS.

?5.	Turn the vehicle to the ON mode, then wait for 10 seconds.

?6.

Check for DTCs with the HDS.

DTC Description	DTC
B00C0-87 No signal from the front passenger's weight sensor (front inner side)

Is DTC B00C0-87 indicated?


	YES

The front passenger's weight sensor is OK. Faulty SRS unit or poor connection at SRS unit connector B (39P) and the SRS unit. Check the connection; if the connection is OK, check for any authorized service information related to the DTCs or symptoms you are troubleshooting or replace the SRS unit.?


	NO

Faulty front passenger's weight sensor. Replace the front passenger's weight sensors as an assembly.?