Remove the clutch line bracket (A) and the clutch line clamp (B).

Remove the slave cylinder (C).

Carefully move the slave cylinder out of the way to avoid bending the clutch line.

NOTE:

Disconnect the connectors (A).

Remove the harness clamp bracket (B).

Remove the harness clamp (C).

Remove the harness holder (A).

Remove the lock pins (A).

Remove the change wire bracket bolts (B).

Disconnect the change wire from the change lever assembly (C).

Carefully remove the change wire and the change wire bracket (D) together to avoid bending the change wire.

NOTE: Do not wipe off the grease of the change wire ends (E).

Install the engine support hanger (AAR-T1256) onto the vehicle as shown.

Attach the hook to the slotted hole in the universal lifting eyelet.

Tighten the wing nut (A) by hand, and lift and support the engine/transmission.

NOTE: Be careful when working around the windshield.

Support the front subframe with a transmission jack (A).

Remove the front subframe.

Remove the lower transmission mounting bolts (A).

Pull the transmission away from the engine until the transmission mainshaft clears the clutch pressure plate.

Slowly lower the transmission about 150 mm (5.91 in).

Check once again that all hoses and harness are disconnected and free from the transmission.

Lower the transmission.

Make sure the two dowel pins (A) are undamaged and installed in prescribed holes on the engine block as shown. Replace the dowel pins if they are damaged.

Place the transmission on the transmission jack, and raise it to the engine level.

Align the transmission mainshaft and the clutch pressure plate.

Move the transmission inward until there is no clearance between the transmission housing and the engine block.

Install the lower transmission mounting bolts (A).

Support the front subframe with a transmission jack (A).

Raise the front subframe up to the body.

Tighten the mounting bolts to the specified torque.

Remove the transmission jack.

Loosen the torque rod mounting bolt (A).

Position the transmission mount (A).

Tighten new transmission mount mounting bolts (B) and loosely install new transmission mount bracket mounting bolt and nuts (C).

Install the ground cable (D).

Install the harness holder (A).

Connect the connectors (A).

Install the harness clamp bracket (B).

Install the harness clamp (C).

Connect the change wire ends (A) to the change lever assembly (B).

NOTE: Do not wipe off the grease of the change wire ends (C).

Install the change wire bracket (D).

Install the lock pins (E).

Apply a light coat of super high temp urea grease (P/N 08798-9002) to the push rod (A) of the slave cylinder (B).

Install the slave cylinder.

Install the clutch line bracket (C) and the clutch line clamp (D).

NOTE: Be careful not to bend the clutch line.